Purple Custom Xbox Controller

Its been a while since I’ve posted, so I thought I’d throw up a quick post of a relatively quick project my wife and I did this last weekend.

wpid-IMG_20140302_143936.jpg

Disassembling the controller was fairly easy, the most difficult part was getting out the security torx screws, without a small enough security torx driver. Here’s a tip: you can just use a flat head driver small enough to fit in one side of the screw. There are 7 screws, the 6 obvious ones, and then one under a small label in the battery compartment. That last one can fool you if you don’t go looking for it.

After getting the controller unscrewed, next step is to pull all the electronics out, and wash the plastic. The controller we were using was by no means a new one, so it got a good scrub in soapy water to make sure there was no grease and oil left on it.

I was too impatient to let the plastic air dry, so I fired up my air-compressor to blow the water off them. It makes a short effort of drying everything off.

With the plastics dry, it was painting time. I sprayed a primer on all the parts and then left it out in the sun while we went to the shop to get the colours for the project. Diana chose the colours for her controlelr, a nice purple, and a complimenting pink for highlights. The paints we chose in the end didn’t actually need a primer coat, but It was already done, and shouldn’t hurt things. When choosing your paint, its usually a good idea to get a good quality paint. Its a bit thicker than the cheapo stuff, and covers better usually. You can make do with cheap paint, but you will really want to do use a primer, and you’ll probably need to do more coats.

The paint went on pretty well, if not a bit fast. There were a few bubbles that formed in places, but they were fixed after a quick sand and a second coat.

After letting the controller dry for a couple of hours, it was time to put it back together. Everything just slots back where it came from, and screwed back down, and hey presto! a purple and pink Xbox controller!

Completed Controller

And that’s it. I didn’t think to get any more photos of the process, sorry. Its not too difficult though.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s